Chapter 6, "Using The Setup Utility," On; Re-Run Test; Replace The Component That Is Called Out In Warning Statement; Replace The Component Under Test - Lenovo E100 Hardware Maintenance Manual

Diagnostic Error Code
011-197-XXX
Serial port test warning
011-198-XXX
Serial port test aborted
011-199-XXX
Serial port test failed, cause unknown
011-2XX-XXX
Serial port signal failure
014-000-XXX
Parallel port Interface Test Passed
014-001-XXX
Parallel port Presence
014-002-XXX
014-003-XXX
Parallel port Timeout/Parity error
014-013-XXX
014-014-XXX
Parallel port Control Signal/Loopback test
failure
014-015-XXX
Parallel port External Loopback failure
014-027-XXX
Parallel port Configuration/Setup error
014-03X-XXX
014-04X-XXX
Parallel port failure
014-195-XXX
Parallel port Test aborted by user
FRU/Action

1. Make sure the component that is called

out is connected and/or enabled. See

Chapter 6, "Using the Setup Utility," on

page 49

2. Re-run test

3. Replace the component that is called out
in warning statement

4. Replace the component under test

1. If a component is called out, make sure
it is connected and/or enabled. See
Chapter 6, "Using the Setup Utility," on
page 49
2. Flash the system and re-test. See "Flash
update procedures" on page 111

3. Go to "Undetermined problems" on page

78
1. Go to "Undetermined problems" on page
78
2. Flash the system and re-test. See "Flash
update procedures" on page 111
3. Replace component under function test
1. External serial device

2. System board

No action
1. Remove external parallel device, if
present
2. Run setup, enable port
3. System board
System board
System board
1. Wrap plug
2. System board
1. Run Setup, enable port
2. Flash the system. See "Flash update
procedures" on page 111
3. System board
System board
Information only
Re-start the test, if necessary
Chapter 7. Symptom-to-FRU Index
61