Running Tests; Test Results - Lenovo E100 Hardware Maintenance Manual

Running tests

There are four ways to run the diagnostic tests.
v Using the cursor movement keys, highlight Run Normal Test or Run Quick Test
v Press F5 to automatically run all selected tests in all categories.
v From within a test category, press Ctrl-Enter to automatically run only the
v Using the cursor movement keys, highlight a single test within a test category,
Press Esc at any time to stop the testing process.
Test results (N/A, PASSED, FAILED, ABORTED) are displayed in the field beside
the test description and in the test log. See "Viewing the test log" on page 47.
To select one or more tests, use the following procedure.
1. Open the corresponding test category.
2. Using the cursor movement keys, highlight the desired test.
3. Press the space bar.
4. Repeat steps 2 and 3 above to select all desired tests.

Test results

Diagnostics test results produce the following error code format:
v Function Code:
v Failure Type:
v DeviceID:
v Date:
v ChkDigits:
v Text:
44
Lenovo 3000 E100
from the Diagnostics menu and then press Enter.
This automatically runs a pre-defined group of tests from each test category.
Run Normal Test runs a more extensive set of tests than does Run Quick Test
and takes longer to complete.
selected tests in that category.
and then press Enter. This runs only that test.
A selected test is marked by >>. Pressing the space bar again de-selects a test
and removes the >>.
Function Failure Type
Code
Represents the feature or function within the PC.
Represents the type of error encountered.
Contains the component's unit-ID which corresponds to either a fixed disk
drive, removable media drive, serial or parallel port, processor, specific RIMM,
or a device on the PCI bus.
Contains the date when the diagnostic test was run. The date is retrieved from
CMOS and displayed using the YYYYMMDD format.
Contains a 2-digit check-digit value to ensure the following:
– Diagnostics were run on the specified date.
– Diagnostics were run on the specified computer.
– The diagnostic error code is recorded correctly.
DeviceID Date ChkDigits Text