Display Bezel; Removing The Display Bezel - Dell Inspiron One 2205 Service Manual

Back to Contents Page
Display
Dell™ Inspiron™ One 2205 Service Manual
Display Bezel
Display Panel
Display Cable
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
Display Bezel

Removing the Display Bezel

1. Follow the instructions in Before You
2. Remove the system board (see
3. Remove the 19 screws that secure the display bezel to the chassis.
4. Carefully peel the silver foil that adheres the camera module to the chassis from the chassis.
5. Make a note of the camera cable, infrared-card cable, and Bluetooth
6. Turn the computer over.
7. Release the three tabs that secure the display bezel to the chassis.
8. Using your fingertips, carefully pry up the inside edge of the display bezel.
9. Lift the display bezel away from the computer.
10. Remove the camera module (see
11. Remove the infrared card (see
12. Remove the Bluetooth card (see
Begin.
Removing the System Board).
Removing the Camera Module).
Removing the Infrared Card).
Removing the Bluetooth Card).
®
-card cable routing and release the cables through the slots on the chassis.