4. Adhere the silver foil on the processor heat-sink.
5. Connect the processor heat-sink fan cable to the connector (CPU FAN) on the system board.
6. Replace the system-board shield (see
7. Replace the rear stand cover (see
8. Follow the instructions from
9. Replace the back cover (see
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
10. Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
Replacing the System-Board
Replacing the Rear Stand
Cover).
step 4
to
step 7
in
Replacing the Front
Replacing the Back
Cover).
Shield).
Stand.