Dell Inspiron One 2205 Service Manual page 33

Back to Contents Page
Infrared Blaster Connector (Optional)
Dell™ Inspiron™ One 2205 Service Manual
Removing the Infrared (IR) Blaster Connector
Replacing the Infrared (IR) Blaster Connector
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
Removing the Infrared (IR) Blaster Connector
1. Follow the instructions in Before You
2. Follow the instructions from
3. Remove the nut that secures the IR blaster to the system-board shield.
4. Release the IR blaster connector from the slot on the system-board shield.
5. Lift the IR blaster connector along with its cable away from the system-board shield.
1 IR blaster connector
Replacing the Infrared (IR) Blaster Connector
1. Follow the instructions in Before You
2. Slide the IR blaster connector into the slot on the system-board shield.
3. Replace the nut that secures the IR blaster connector to the system-board shield.
4. Follow the instructions from
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
5. Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
Begin.
step 2 to step 9 in Removing the System-Board
2 nut
Begin.
step 4 to step 11 in Replacing the System-Board
Shield.
Shield.