1. Follow the instructions in
Before You
2. Replace the speaker (see
Replacing the
3. Align the slots on the middle frame with the connectors on the system board.
4. Align the screw holes on the middle frame with the screw holes on the chassis.
5. Replace the 13 screws that secure the middle frame to the chassis.
6. Route the cables through the routing guides on the middle frame.
7. Route the speaker cable through the routing guides and connect the speaker cable to the connector (CN10) on the system board.
8. Replace the system-board shield (see
9. Replace the rear stand cover (see
10. Follow the instructions from
11. Follow the instructions from
12. Replace the back cover (see
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
13. Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
Begin.
Speakers).
Replacing the System-Board
Replacing the Rear Stand
Cover).
step 4
to
step 7
in
Replacing the Front
step 5
to
step 7
in
Replacing the Optical
Replacing the Back
Cover).
Shield).
Stand.
Drive.