Reset Authentication To Factory Defaults; Table 17 Factory Default Passwords - Emerson Liebert IntelliSlot IS-WEB485ADPT Installation Manual

5.8

Reset Authentication to Factory Defaults

You may reset the Administrator and General User usernames and passwords to the factory defaults.
If you forget your username or password, you may reset them using a serial configuration cable
connection (see Section 2.1.1 or 2.2.1 - Connect the Cable), which provides direct access to the card
without a username or password. To enter a new username and password, see 5.7 - Change
Username / Password.
Table 17 Factory default passwords
Type of User
Administrator
General User
Terminal Emulation (Serial or TCP/IP Connection) / Telnet
To reset the usernames and passwords to the factory defaults:
1. Choose IP Network Settings from the Main Menu, then Reset Authentication to Factory
Defaults.
Reset authentication to factory Defaults? [y/n] ?>
2. Enter y to reset the Administrator and General User usernames and passwords to the default
settings.
NOTE
This feature is not available through the Web interface
Factory Default
Username Liebert
Full access to configuration and control
functions, as well as viewing privileges
Password Liebert
Username User
Viewing privileges only—no access to
configuration or control functions
Password User
Description
27
Network Settings