Table 11 Management Protocol Ranges; Management Protocol; Table 11 Table - Emerson Liebert IntelliSlot IS-WEB485ADPT Installation Manual

Web Interface
To access the DNS menu through the Web interface:
• Click on the Configure tab, then Network Settings in the left panel and finally Edit beneath
the table of parameters and descriptions. After making changes, click Save.
Configure
tab
Network
Settings
Click Edit
to change
settings
5.3

Management Protocol

The Management Protocol Menu allows you to enable or disable
SNMP and configure management protocols. Consult your network
administrator for these settings.
Terminal Emulation (Serial or TCP/IP Connection) / Telnet
To change any parameter:
1. Choose IP Network Settings from the Main Menu, then Management Protocol.
2. Select an option to change, then use the following guide to make changes.
Table 11 Management protocol ranges
Parameter
SNMP Agent
SNMP
Communications
Enable or disable SNMP for remote management.
Set up access privileges, configure the
Web card to send traps, described in the
next section, SNMP Communications
Menu.
For details on viewing support information,
see 9.2 - Events and Parameters.
Description & Telnet Menus
Enable SNMP Agent? [y/n] ?>
SNMP Communications Menu
-------------------------
1: Authentication Traps
2: RFC-1628 (UPS) MIB
3: - Traps
4: Liebert Global Products MIB
5: - Condition Traps
6: - System Notify Tra
7: Heartbeat Trap Interval''
8: Display/Modify Communities
9: Display/Modify Trap Communities
A: Support Information
<ESC>: Cancel menu level
Please select a key ?> 1
15
Network Settings
Obtain
address
automatically
Specify
address
Options for
how long
card retains
resolved
addresses
Management Protocol Menu
-------------------------
1: SNMP Agent enabled
2: SNMP Communications
<ESC>: Cancel menu level
Please select a key ?>
'no'
'enabled'
'enabled'
'enabled'
'enabled'
p 'enabled'