Datalogic QUICKSCAN 6000 PLUS Programming Manual page 87

Read Verification by Symbology
To set the minimum read requirement for a desired symbology:
1. Scan the SET label.
2. Scan one symbology label below to select the symbology to
be verified.
3. Scan the label on the following page representing the amount
of times you wish a bar code label of that symbology type to
be read before transmission to the host.
4. Repeat steps one through three above until read verification has
been selected for all symbologies you desire to be verified.
5. Scan the END label.
SET ----------------------------------------------
V
ERIFY
V
ERIFY
V
ERIFY
V
ERIFY
V
ERIFY
V
ERIFY
1
Instore labels are UPC-A bar codes with a number system character of 2 or 4, and EAN-8 and
EAN-13 bar codes with a Flag 1 character of 2.
Programming Guide
UPC-A -------------------
UPC-E -------------------
EAN-8 --------------------
EAN-13 ------------------
1
I L
NSTORE ABEL --------------------
C 39 ------------------
ODE
83