Check Thermostat Operation; Disabling Automatic Changeover Mode; Fan Operation; Heating System - White Rodgers 1F92 Operating Instructions Manual

DISABLING AUTOMATIC DISABLING AUTOMATIC DISABLING AUTOMATIC DISABLING AUTOMATIC DISABLING AUTOMATIC
CHANGEOVER MODE. CHANGEOVER MODE. CHANGEOVER MODE. CHANGEOVER MODE. CHANGEOVER MODE.
(Installer table step 13). This
thermostat, as configured at the
factory, provides automatic
changeover, which allows the
thermostat to switch between
heating and cooling to maintain
temperature. In this configuration,
when you press the SYSTEM
button, the thermostat will go
through HEAT-OFF-COOL-AUTO
modes (HEAT-EMER-OFF-COOL-
AUTO for heat pumps). Select
HEAT(-EMER)-OFF-COOL to
disable the automatic changeover
feature.

CHECK THERMOSTAT OPERATION

CHECK THERMOSTAT OPERATION
CHECK THERMOSTAT OPERATION CHECK THERMOSTAT OPERATION CHECK THERMOSTAT OPERATION

FAN OPERATION

FAN OPERATION FAN OPERATION FAN OPERATION FAN OPERATION
If your system does not have a G
terminal connection, skip to
"Heating System" section.
1. Turn power on to the system.
2. Press PROGRAM
FAN ON FAN ON
3. Press until FAN ON FAN ON is FAN ON
FAN
displayed. The fan should begin
to operate.
FAN AUTO FAN AUTO
4. Press until FAN AUTO FAN AUTO FAN AUTO
FAN
is displayed. The fan should stop
operating.
20

HEATING SYSTEM

HEATING SYSTEM HEATING SYSTEM HEATING SYSTEM HEATING SYSTEM
1. Press PROGRAM
2. Press
displayed. If the heating system has
a standing pilot, ensure that it is lit.
. 3. Press
RUN
setting above room temperature. The
heating system should begin to
operate.
4. Press
ture below room temperature. The
heating system should stop
operating.
.
RUN
HEAT HEAT
until HEAT HEAT HEAT is
SYSTEM
to adjust thermostat
to adjust tempera-