Activate Run Prg By Telephone; Compressor Run Time; Keypad Lockout; Automatic Changeover - White Rodgers 1F92 Operating Instructions Manual

Activate RUN PRG Activate RUN PRG Activate RUN PRG Activate RUN PRG Activate RUN PRG
by Telephone. by Telephone. by Telephone. by Telephone. by Telephone.
(User menu, Item 8) With the
optional X-10 Touch Tone Control-
ler and a Universal Low Voltage
Module, UM506, installed, you can
make a telephone call to run your
program if the thermostat has been
set to Hold or Vacation Hold. These
optional items are available from
www.x10.com, or 800-675-3044.

Compressor Run Time.

Compressor Run Time. Compressor Run Time.
Compressor Run Time. Compressor Run Time.
(User menu, Item 9 and 10) You
can see how long the compressor
has run (in hours) by viewing the
User table, Item 9. You can see how
long the system Auxiliary has run
(in hours) by viewing the User table,
Item 10. These can be reset to 00
when displayed by pressing
and at the same time.

Keypad Lockout.

Keypad Lockout. Keypad Lockout. Keypad Lockout. Keypad Lockout.
(Keypad Lockout table) This
security feature allows you to lock
out the keypad to prevent unautho-
rized tampering with the program.
Two levels of security are available,
Total Keypad Lockout or Partial
Keypad Lockout. Total Keypad
Lockout renders all buttons
inoperative. Partial Keypad Lockout
allows only the or
operate for temporary temperature
overrides. It also limits the tempera-
ture to the maximum heating and
minimum cooling temperatures used
in your program. This is especially
useful in buildings where unsched-
uled events are common. Anyone
can change the temperature, but
only between the temperatures you
set and only for the number of hours
32
you specify if you set up your Hold
Till timing (see "Temporary
Program Override" (page 37). To
select or deselect this feature, refer
to the CONFIGURATION section
(page 25, Keypad Lock menu).
TRADITIONAL FEATURES TRADITIONAL FEATURES TRADITIONAL FEATURES TRADITIONAL FEATURES TRADITIONAL FEATURES

Automatic Changeover.

Automatic Changeover.
Automatic Changeover. Automatic Changeover. Automatic Changeover.
If you have a heating/cooling
system, the thermostat can be set to
to
automatically switch the system
between heating and cooling as
needed. To set your thermostat to
this operating mode, press
button until AUTO is displayed on
the screen.
Factory Preprogrammed Factory Preprogrammed
Factory Preprogrammed Factory Preprogrammed Factory Preprogrammed
Times and Temperatures. Times and Temperatures. Times and Temperatures. Times and Temperatures. Times and Temperatures.
This thermostat has been pro-
grammed at the factory. The chart in
SYSTEM