White Rodgers 1F92 Operating Instructions Manual page 25

CONFIGURATION
The configuration menus allow you
to set certain thermostat operating
characteristics to your system or
personal requirements.
To enter the User Configuration menu,
press PROGRAM to make sure
RUN
the thermostat is in the run program
mode, then press TIME FWD
TIME BACK at the same time. The
display will show the first item in the
configuration menu.
The following charts (pages 24 & 25)
describe each item on the menus. Press
TIME to move forward to the
FWD
next item in the menu or TIME
to move backward to the previous item.
Set these according to your personal
preference using or
enter the Keypad Lock menu, while in
the User Menu, press and hold TIME
and TIME
FWD
two seconds.
To exit either menu and return to normal
operation, press PROGRAM
re-enter to the User menu at any time
press PROGRAM
and
TIME FWD and TIME
same time. While in the menus, if you
do not press any buttons for two
minutes, the thermostat will revert to
normal operation.
BACK
. To
Configuration
BACK for at least
. To
RUN
, then press
RUN
BACK at the
23