Installer Configuration; Entering The Configuration Menus - White Rodgers 1F92 Operating Instructions Manual

INSTALLER CONFIGURATION

INSTALLER CONFIGURATION
INSTALLER CONFIGURATION INSTALLER CONFIGURATION INSTALLER CONFIGURATION
BEFORE TURNING POWER
ON, please read the following
instructions. Before operating the
system, you must configure the
thermostat to operate properly
with your equipment.
The thermostat, as it comes from the
factory, is configured to operate a
standard multi-stage electric
forced hot air system with a single
stage air conditioning compressor
and fan. In this configuration, the
thermostat will turn on the fan
immediately on a call for heat. If
you are unsure whether your system
requires the thermostat to control
the fan, contact your furnace/air
conditioning system manufacturer or
a qualified heating/air conditioning
service person.
Your new thermostat has an Installer
menu, which allows you to custom-
ize the thermostat to meet your
requirements.
(The thermostat also has a User
menu and a Keypad Lockout
menu; these menus are explained
further in the CONFIGURATION
section.)
The menu settings can be changed at
any time to meet system or personal
requirements.
ENTERING THE ENTERING THE ENTERING THE
ENTERING THE ENTERING THE
CONFIGURATION MENUS CONFIGURATION MENUS CONFIGURATION MENUS
CONFIGURATION MENUS CONFIGURATION MENUS
After properly wiring the thermo-
stat, turn on power to the system.
Momentarily press PROGRAM
to make certain the thermo-
RUN
stat is in the run program mode,
13
Installation
then press TIME and TIME
FWD
at the same time to enter the
BACK
User Configuration menu. When the
display changes to the first item in
the configuration menu, release the
buttons. Then press and hold SET
and SET for approxi-
TIME DAY
mately 3 seconds to enter the
Installer menu. The display will
change to show the first item on the
Installer menu (multi-stage/heat
pump selection). Use the following
text, along with the Installer table
on page 16, to guide you through
the menu.
Once in the menu, you set each item
to the proper selection using
or , then press TIME
change the display to the next item
or TIME to return to the
BACK
previous item.
to
FWD