D-Link DCS-5220 - Wireless Pan/Tilt Internet Camera Network User Manual page 72

Section  - Configuration
Specific alert actions can be performed by setting the options in this window.
Enable motion detect:
Enable digital input:
Digital input alert:
Record # secs before event:
Record # secs after event:
Media Type:
You can "drag and drop" in the grid area of the camera list to change the sequence of the connected Network Cameras,
which is shown below. This will allow you to rearrange the cameras in an order of your choice. Once the camera is
moved to a specified location, the proceeding cameras will then move 1 position up or 1 position down depending on
which direction the selected camera was moved.
D-Link DCS-50 User Manual
This will trigger an alert sound that has been specified in the section titled "Display & UI Settings\Local
Alert Settings". Check this option to enable audio alerts for the selected camera.
This function is similar to "Enable Motion Detect" mentioned above. Once this option has been checked,
a digital input device will be able to trigger an alert sound and recording.
Note: The digital input/output is not available for the DCS-5220 model.
This application software provides options for you to define the triggering criteria for the digital input of
the camera. The alert of the digital input can be defined as high-level triggered or low-level triggered.
Note: The digital input/output is not available for the DCS-5220 model.
Once the automatic video recording has been activated, you can change this setting to regulate the
recording of triggered events. Recording will start from the specified number of seconds before the alert
event has been invoked.
Recording will last for the specified number of seconds after the alert event has been invoked.
You can specify which media type you want to record: Video, Audio, or both.
Changing the Camera Order in the List
Alert Settings
Recording Settings