Emerson SUMMER NIGHT CF652AW00 Owner's Manual page 4

MOTOR
COUPLING
3/16-24 x 1/2"
SETSCREW
HAIRPIN
CLEVIS PIN
CLIP
JAMNUT
CEILING
COVER
CLEVIS
PIN
3/16-24 x 1/2" SCREW
WITH JAM NUT
MOTOR COUPLING
Figure 1
4. Back off the jam nut until it rests loosely against the
setscrew head (supplied). Install the setscrew in
the motor coupling (Figure 1) and tighten securely
while pulling up on the downrod. Using a 5/16-inch
open end wrench or pliers, tighten the jam nut
securely against the motor coupling.
NOTE: The setscrew and jam nut must be properly
installed as described above, or fan wobble could
result.
5. The fan comes with blue, black and white leads
that are 80-inches long. Before installing the fan,
measure up approximately 6 to 9-inches above top
of hanger ball/downrod assembly. Cut off excess
leads and strip back insulation 1/2-inch from end of
leads.
IMPORTANT: THE SIDE OF THE FAN BLADE
HAVING THE RIB LINE MUST BE FACING
UPWARDS AS SHOWN IN FIGURE 2.
6. Mount blade flanges to fan blades using three
3/16-24 x 5/16" slotted phillips washer head screws
per blade (Figure 2).
3/16-24 x 5/16" SLOTTED PHILLIPS
WASHER HEAD SCREW (3)
RIB LINE
FAN BLADE
(THIS SIDE UP)
BLADE FLANGE
Figure 2
WARNING
!
To reduce the risk of personal injury, do not bend the
blade flange when installing the blade flanges,
balancing the blades or cleaning the fan. Do not
insert foreign objects in between rotating fan blades.
NOTE: Remove and discard the four shipping
spacers and screws from the motor hub.
7. Turn the fan assembly upside down in preparation
for mounting the fan blade assemblies.
8. Rotate the motor hub until the flange screw hole is
HANGER BALL/
DOWNROD ASSEMBLY
CLEVIS
PIN
HAIRPIN
CLIP
Figure 3
9. The blade flanges have an interlocking feature
10. Engage the connector of the switch housing
Figure 4
11. Remove the three switch housing mounting
NOTE: Do not pinch wires between the switch
housing assembly and the switch housing plate.
4
next to the cutout in the switch housing plate. Attach
one blade assembly to the motor hub using two 1/4-
20 x 1/2" Phillips oval head flange screws. Make
sure the screws are NOT tightened. (Figure 3.)
Repeat this procedure for the other four blade
assemblies.
SWITCH HOUSING
PLATE
MOTOR HUB
that must be fully engaged before tightening the
screws. Make sure all the flanges are properly
engaged and then tighten the flange screws. If
one of the flanges does not seat properly on the
motor hub, loosen the adjacent flange screws, re-
engage and reseat the flanges, then tighten the
screws again.
assembly with the motor connector (Figure 4).
The two connectors are keyed and color-coded
and must be mated correctly (color-to-color)
before they can be engaged. Make sure the
connector latch closes properly.
SWITCH
HOUSING
ASSEMBLY
screws (Figure 4) from the switch housing plate.
Position the switch housing assembly on the
switch housing plate and align the holes in the
switch housing assembly with the holes in the
plate. Secure the switch housing assembly by
installing the three mounting screws (Figure 5).
BLADE FLANGE
1/4-20 X 1/2" PHILLIPS OVAL
HEAD FLANGE SCREWS (2)
SWITCH HOUSING
CONNECTOR
MOTOR CONNECTOR
SWITCH HOUSING
MOUNTING SCREW