Tools Needed For Assembly; Unpacking Instructions - Emerson BP7251 Owner's Manual

This Manual Is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips head screwdriver
Five wire connectors (supplied)
MATERIALS
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would
be a 3-conductor (2-wire with ground) of the following
size:
For your convenience, check-off boxes are provided next to each step. As each step is completed, place a
check mark in the box. This will insure that all steps have been completed and will be helpful in finding
your place should you be interrupted.
WARNING
!
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
WARNING
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson. Substitution of parts or accessories not
designated for use with this product by Emerson
could result in personal injury or property damage.
1. Open carton containing your ceiling fan. Remove
the top half of the styrofoam packing. Remove
parts and check to see that you have received the
following:
a. Fan motor and shade assembly
b. One motor cover
c. One ceiling cover
d. Five blade flanges
e. One hanger ball/downrod assembly
f. One hanger bracket
g. One yellow lead assembly uplight
h. One downrod, 18" length
i. Three rod assemblies
j. One rod support assembly
k. One light kit plate assembly
l. One light kit adapter assembly
m.One glass shade
n. One loose parts bag containing:
1. One setscrew
2. One 5/32" hex wrench
3. One 5/64" hex wrench
4. Eleven 10-32 x 5/8" oval head screws
5. Two 1" threaded studs
6. Two 1-1/4" threaded studs
7. Four knurled knobs
8. Four lockwashers
9. Five wire connectors
10. Three 5/32-32 x 3/16" screws
One stepladder
One wire stripper

Unpacking Instructions

3
Installed Wire Length
Up to 50 ft.
50-100 ft.
WARNING
!
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan. If you feel you do not
have enough wiring knowledge or experience, have
your fan installed by a licensed electrician.
11. One finial nut
12. One hairpin clip
13. One clevis pin
14. Sixteen 10-32 x 3/8" pan head screws
15. Sixteen flat washers
16. One jumper assembly
17. One washer, motor shaft
18. One hex nut 1/8-27
NOTE: Place the parts from the loose parts bags
in small containers to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.
NOTE: Fan blades are ordered separately and are
packaged in separate carton.
LOOSE
PARTS
BAG
BLADE
FLANGES
CEILING
COVER
ROD SUPPORT
ASSEMBLY
Wire Size A.W.G.
14
12
FAN MOTOR
HOUSING AND
SHADE ASSEMBLY
YELLOW
LEAD
ASSEMBLY
UPLIGHT
HANGER BALL/
DOWNROD
MOTOR
ASSEMBLY
COVER
HANGER
BRACKET
LIGHT KIT
PLATE
ASSEMBLY
LIGHT KIT
ADAPTER
ASSEMBLY
GLASS
SHADE
18" DOWNROD
ROD ASSEMBLY (3)