On Screen Display Functions - Hitachi DT3130E User Manual

To turn the power on and off, push the "l" and "O" sides respectively. The "POWER'
LED lights to indicate the power is on. (It takes 20 to 30 seconds for the display to be
stable. The back lights may flicker during this time.)
The monitor screen is designed to tilt up to 30 degrees upward and 5 degrees downward.
Choose the angle that suits you best.
H ON-SCREEN DISPLAY FUNCTIONS
To optimise the display use the on-screen display (OSD) as described below.
The display size, image position and brightness depend on the system hardware. Make
screen adjustments after carefully reading this manual. If the screen cannot be adjusted as
desired, refer to your computer system manual to check if the display timing is consistent
with that shown on page 29.
Brightness Control
When the OSD is not active, pressing the A or Y buttons will cause the BRIGHTNESS
Control Screen to appear.
BRIGHTNESS Control Screen
Pressing the A button increases brightness, pressing the V button reduces brightness.
(The factory default brightness is 150nascale of Oto31.) Holding the A or 7
buttons for more than one second will cause the brightness to continue increasing or
decreasing.
If the MENU button is pressed (or no button pressed for about three seconds) the
original display resumes.
The SELECT and BACK buttons are not active.
.
If you want to save the adjusted brightness value, use "SETTING-SAVE' (see page 20).
4
14