Remote Control; Connection To The Tv - Hitachi HDR255 Instruction Manual

Remote Control

First open the battery cover on the underside of the remote control. Put in both batteries 1.5Volt (RO3/AAA)
referring to the imprinted symbols (+/-) in the battery case and put on the battery cover again. While using
the remote control, direct it towards the front side of the receiver. If the remote control does not work or the
chosen function does not work, the batteries are most probably exhausted and they should be replaced as
soon as possible. Please use only the leak proof batteries. It is best to remove the batteries from the remote
unit if you will not be using the remote control unit for long time.

Connection to the Tv

Connect your set-top box with a scart cable using the TV scart connector on the rear panel to your television's
scart connector. The set-top box gives RGB or CVBS output. If you want to get the picture via scart connector
and your TV's scart connector has an RGB input, then you can switch your digital set-top box to RGB mode, by
toggling TV out menu to RGB mode, in configuration menu. So, you will be able to achieve high performance
from your digital set-top box.
English - 6 -