Remote Control; Getting Started - Hitachi HDR082 Instruction Manual

REMOTE CONTROL

1. Press the mark on the cover and slide it in the direction of the arrow.
2. Insert the batteries making sure the polarities correctly match the + and - marks inside the battery
compartment.
3. Attach the cover and slide it until it clicks into place.
Incorrect use of the batteries may cause them to leak or explode. Please follow the precautions below.
•Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• Insert the batteries making sure the polarities correctly match the + and - marks inside the battery
compartment.
• Batteries of different types have different properties, therefore do not mix batteries of different types.
• Do not mix new and old batteries.
This may shorten the life of new batteries or may cause old batteries to leak.
• Remove the batteries from the remote control once they have run out, as leaving them in can cause
them to leak.
Battery fluid from leaked batteries is harmful to skin, therefore ensure that you wipe them first and then
remove them using a cloth.
• Remove the batteries from the remote control if you will not be using the remote control for a long
time.
• Comply with the rules accordance of each local government when disposing of worn-out batteries.
Replacement batteries for this unit are 1.5 Volt (R03/AAA).

GETTING STARTED

Before connecting, ensure that the power cord of the unit is unplugged from the AC outlet and turn off
the devices to be connected. After making all connections (Diagrams on page 11), turn on the unit first
and then the other devices.
After plugging in the mains cord, wait until a blue light is viewable on the front panel (Standby Mode).
"NOTE" - When the unit is first powered up, please wait a short while before activating the receiver as
the unit's software needs to be initialised and the hard disk checked.
You can turn on your unit by pressing the Standby button on the remote control. Notice that the blue
light on the front panel will turn blue.
The unit is equipped with output terminals that support RGB, S-video and CVBS video signals.The
image quality is highest in the order of the RGB signal, the S-video signal and the CVBS video signal.
10