Connecting The Monitor; Signal Cable Connection; Power Cord Connection - Hitachi CM823FET User Manual

INSTALLATION (Continued)

Connecting the monitor

Front View
1. Installation
Install the monitor in a suitable environment.
Do not place the monitor on an unstable base.
Do not expose the monitor to rain, moisture, dust, corrosive gases, vibrations, etc. so
as to prevent electrical shock or fire hazard.
Avoid placing the monitor in direct sunlight or near heating appliances.

2. Signal Cable Connection

(1) Use video signal cable which is included in the carton box.
(Cable part number: DC190018510 )
(2) Insert the connector of a signal cable to the Signal Input Connector of the monitor, with
attention to the suitability, and secure the screws on the connector shell firmly.
(3) Connect the other connector end of the signal cable to the host computer.

3. Power Cord Connection

(1) Make sure to use a power cord that meets the safety standard of the country in which
you are using the monitor.
(2) Insert the connector of the power cord to the AC Input of the monitor.
(3) Insert the plug of the power cord into a power outlet of the correct voltage.
Before inserting the plug of the power cord into a power outlet of the correct voltage,
check that the connection portion of the power cord is clean (with no dust).
Then firmly insert the plug of power cord into a power outlet to avoid an electrical shock or
fire hazard.
1 - 8
to the power outlet of
the correct voltage
Rear View
to the host
computer