Installation - Hitachi CM761ET User Manual

INSTALLATION
! ~ Before installing, read the chapter "CAUTIONS carefully.
Checking the contents
Check whether the consignment agrees with the details in the following delivery note.
Should you discover that the equipment has been damaged during transport or that the
consignment does not correspond to the delivery note, notify your dealer immediately.
Delivery Note: one Monitor
one Power Cord
this User Manual
~
NOTE:
Keep the original packing material for future reshipment.
Connecting the monitor
F
s
P
T
Front View
power ~or~
_./&
Rear View +
to
a poweroutlet to the host
of the correctvoltage computer
1. Installation
Install the monitor in an suitable environment.
~ @ Do not place the monitor on an unstable base.
~ @ Do not expose the monitor to rain, moisture, dust, corrosive gases, vibrations, etc.
so as to prevent electrical shock or fire hazard.
~ @ Avoid placing the monitor in direct sunlight or near heating appliances.
2. Signal Cable Connection
Insert the Signal Input Connector of the monitor to the host computer, with attention to it's
suitability, and secure the screws on the connector shell firmly.
3.
Power Cord Connection
(1) Make sure to use the power cord meeting the safety standard of the country in which
you are using the monitor.
(2)
Insert the connector of a power cord to the AC Inlet of the monitor.
(3) Insert the plug of the power cord to a power outlet of the correct voltage.
Before inserting the plug of the power cord into a power outlet of the correct
voltage, check that the connection portion of the power cord is clean (with no dust).
Then, insert the plug of power cord into a power outlet firmly to avoid electrical
shock or fire hazard.
1-7
—
—