Advertisement
15
CON 2
< Circuit diagram during unlock output >
< Circuit diagram >
The lock and unlock outputs of the CM1000A
are actually two pre-wired relays that can be
configured in the three following ways listed
below. When connecting to a constant 12v+
source, you must fuse the connection.
< Circuit diagram during lock output >
Method 1
Negative Trigger Door Lock
System (W/O Actuator)
Method 2
Positive Trigger Door Lock System (W/O Actuator)
Method 3
External Actuator
CON 3
No.1 Green : (+)12v Ignition Input
This wire must be connected to the vehicles ignition to trigger remote
programming and Valet mode. The proper wire will test 0-volts with the key in
the off position, 12-volts (+)positive while the key is in the on position and 12-
volts (+) positive during crank.
16
< External Actuator >
Advertisement
