CompuSTAR CM1000A User Manual page 10

17
No.2 Blue :
Negative Starter Kill Output
250mA (-) negative output when armed. This wire will provide a (-)
negative output when system is locked and armed, and is pre-wired to the
starter kill relay.
(Note:This wire can also be used to trigger after-market L.E.D. kits and
other after-market accessories. Output must be diode isolated when used
to trigger after-market accessories.)
.... Starterkill Mode ...
.... Anti Jacking Mode ...
Key Cylinder
Relay Relay
85
Starter Wire
87 87a
Cut
86 30
Starter
No.3 Red / Black :
Negative Door Trigger
This wire monitors (-) negative trigger door-pins.
The proper wire will provide a (-) negative trigger only when the doors are
opened.
No.4 Red :
Positive Door Trigger
This wire monitors (+) positive trigger door-pins.
The proper wire will provide a (+) positive trigger only when the doors are
opened.
Key Cylinder
85
Ignition Wire
87
87a
Cut
86 30
Engine
Dome Light Dome Light
Door
Trigger SW
+12V
CON3-3(-) Door Trigger
No.5 Violet/Black : Negative Trunk Trigger
This input will monitor when the vehicles trunk is opened.
Trunk Lamp
(-)Trunk Trigger Input
No.6 Light Blue/White : Positive Brake Trigger
Connect this wire at the brake switch.
The proper wire will test 12-volts (+) positive only when the foot brake
is pressed.
Stop Lamp
Foot Brake S/W
CON3-6(+)Brake Trigger
18
Door
Trigger SW
+12V
CON3-4(+) Door Trigger
+12V
CON 3-5
+12V