Advertisement
9
In a manual transmission vehicle, if the ignition is powered up, the vehicle
can be compression or "bump" started without using the starter. Disabling the
ignition will keep the vehicle from starting.
Anti-Jacking Mode
To use Anti-Jacking mode, the starter kill relay must be rewired to an
ignition kill, and Anti-Jacking mode must be turned on in the programming
options. With Anti-Jacking mode, if someone pulls you out of your vehicle
while it is running and attempts to drive off with it, you can then Panic the
system by holding the
button down for at least 2.5 seconds. The system
will then sound the siren and flash the parking lights, 30 seconds later; the
system will activate the ignition kill which will disable the vehicle. This is so
you can activate Panic mode while the thief is still in range of your remote
and have enough time to get out of immediate danger before the vehicle is
disabled.
Mute Mode - Silent Arm/Disarm
When operating in mute mode, the siren on the vehicle will not sound
during normal operations such as arm/disarm, lock/unlock, etc.
The siren will still sound if the alarm or Panic mode has been triggered. To
activate Mute mode, tap the
and
second. Do the same again to deactivate Mute mode.
Door Open Indicator (Option 3)
With this option turned on, if you leave your car without shutting all of the
doors, the parking lights will flash.
buttons simultaneously for a split
Installation Guide
Installation Guide Table of Contents
Installation Tips and Recommendations
CM1000A Wiring Diagram
CON 1
CON 2
CON 3
CON 4
CON 5
Antenna
Option Menu
Programming Menu Options
Resetting Menu Options
10
Page 11
Page 13
Page 14
Page 15
Page 16
Page 19
Page 19
Page 19
Page 20
Page 21
Page 22
Advertisement
