Compaq SLR Tape Drive User Manual page 51

5-10 Troubleshooting
NOTE: The device selected in the above Event Viewer display is a DAT drive: make sure that
you select the 4/8 GB SLR Drive.
5. Switch the Data buttons from Bytes to Words to make the display easier
to read.
6. Record the last three six characters of the display: these specify the
sense code.
Figure 5-4. A typical Event Detail display
NOTE: If the last six characters are 00 00 00, this indicates that no sense code
has been reported.
Change from
Bytes to Words
Compaq SLR Tape Drive User Guide
Sense Code
03 31 00