Table of Contents
Advertisement
2. Open the release handle (rotate the handle down).
3. Slide the module into the power module bay until it stops.
4. Close the release handle (rotate the handle up).
Installing a fan module
To install a fan module, slide it into the fan module bay until the fan handle locks.
1. Read "Safety" on page v and "Handling static-sensitive devices" on page 26.
2. Slide the module into the fan module bay until the fan handle locks.
Installing an I/O module
To install an I/O module, open the release handle, slide the module into the I/O
module bay of the BladeCenter S chassis. Before installing an I/O module, read
any installation instructions that comes with that I/O module.
Note:
You can find the documentation for I/O modules at the IBM Systems Information
Center, which is at http://publib.boulder.ibm.com/infocenter/systems/index.jsp.
To access the I/O module documentation from this site, click Systems hardware →
BladeCenter information → I/O modules.
Module
filler
I/O
module
Release
handle
(open)
Chapter 2. Installing the BladeCenter S Types 7779 and 8886
43
Advertisement
Table of Contents
