Table of Contents
Advertisement
Installation Of The TFT TV To The Wall
1- To install the TFT TV on the wall, first of all, foot assembly should be removed. (Figure 1).
Unscrew the 6 screws (M4 x 12) that attach the foot assembly to the TFT panel and remove
the foot assembly from the TFT panel.
2- Decide the place on the wall where the TFT panel would be placed. Fix the wall mounting
stencil on the wall.
The stencil is used for placing the wall hangers on the wall, properly.
3- Level and mark with a pencil the 4 mounting points on each wall hanger.
Drill pilot holes for the plastic anchors (7x30) and then fix the wall hangers with 8 screws
(4 x 30).
4- Raise the TFT panel and hang it to the holes on the wall hanger from the 4 hanging screws
at the rear of the TFT panel.
IMPORTANT
1. Please follow the installation instructions carefully as failure to do so may result in injury or
damage to the set.
2. If you do not feel confident in carrying out the installation yourself, please ask a specialist in-
staller to carry out the installation for you.
3. The wall anchors provided are for solid (brick, concrete etc) walls only. For all other wall types
please obtain the correct fixings for the wall type from your hardware retailer. If you are unsure
which anchors to use, please seek professional advice.
4. To avoid potential injury it is advisable to have assistance from another person to carry out this
installation.
5. Hitachi assumes absolutely no responsibility for injuries or damages that may occur due to
improper installation and handling.
TFT PANEL
FOOT ASSEMBLY
FIGURE 1
GB - 1 -
6 SCREWS
(M4 x 12)
Advertisement
Table of Contents
