EMC QLogic User Manual page 91

3. Insert the diskette with the QLogic driver into the diskette drive,
4. Select the driver by pressing
5. If you want to specify drivers for other devices installed in your
6. Continue the installation procedure as though you were installing
Windows 2000 For detailed installation instructions on the HP ProLiant BL20p G2
and BL40p, refer to HP ProLiant BL p-Class server blades Booting Win-
dows systems from 3rd party Storage Array Network (SAN), How To,
located here:
After completing Windows installation, reinstall the QLogic driver
using the steps under Installation Procedure for Windows 2000 and Win-
dows 2003 Hosts on page 2-16.
NOTE: For Windows 2003 installations using the QLogic STORPort driver, it
will be necessary to install the latest supported Microsoft STORPort hotfix
(QFE). Refer to the EMC Support Matrix for the current hotfix version.
Installing and Configuring the QLA4010 iSCSI HBA to boot from an EMC Storage Array
Installing and Configuring the QLogic QLA4010 iSCSI HBA (TOE)
From this point, press
S
need to select Other and press
and press .
ENTER
brought back to the Additional Devices dialog.
system, do so; otherwise press ENTER at the Additional Devices
dialog to continue with Windows installation.
to an internal hard disk. Choose the correct boot disk for your
iSCSI HBA from the list of discovered LUNs.
ftp://ftp.compaq.com/pub/supportinformation/techpubs/
other/5982-3248en_rev1_us.pdf
to specify additional devices. You will
.
ENTER
. The driver loads and you are
ENTER
4
4-17