Procedure To Install Windows Server 2003 On A Fibre Channel Disk (Only For System With Floppy Disk Drive) - EMC QLogic User Manual

Procedure to Install Windows Server 2003 on a Fibre Channel Disk (Only for system
with floppy disk drive).
there, you can configure your zone(s) on the fabric to allow the HBA
to connect to the array properly.
1. Boot with Windows Server 2003 Setup Media (See Microsoft
Documentation for details).
2. Monitor the white bar on the bottom of the screen.
3. Press within 5 seconds when the
F6
install a third party SCSI or RAID driver
displayed.
4. When the message
one or more mass storage devices installed in your
system, or you have chosen to manually specify an
is displayed, insert the QLogic driver diskette.
adapter.
5. Follow the remaining instructions as displayed to complete the
Windows Server 2003 installation.
Configuring an EMC Boot Device
ress F6 if you need to
Setup could not determine the type of
Configuring a Symmetrix Boot Device
message is
3-13
3