Grounding The Generator - Chicago Electric 98452 Operating Instructions Manual

GENERATOR SuPPORT AND MOuNTiNG
Mount the Generator on a concrete slab capable of supporting the weight of the Gen-
erator. The slab must extend on all sides beyond the Frame (41B) by a least one foot.
Contact a cement contractor for slab specifications if necessary. Attach the Frame to
the concrete slab using 3/8" diameter expansion anchor bolts (not supplied).
Note: It is recommended that only a trained and licensed electrician perform this proce-
dure.
Connect a #6 AWG grounding wire (not included) from the Grounding Connector
(8) on the Generator to a grounding rod (not included) that has been driven at least
24 inches deep into the earth. The grounding rod must be an earth-driven copper
or brass rod (electrode) which can adequately ground the Generator.
(See Figure B.)
ThiS uNiT cAN POWER ThE FOLLOWiNG iTEMS
NOTE: Wattages listed above are estimates for that type of equipment only. Check name-
plate wattages on all loads before connecting to Generator.
SKU 98452 For technical questions, please call 1-800-444-3353.

GROuNDiNG ThE GENERATOR

iTEM
1/3 HP Air Compressor
Belt Sander
Drum Mixer
Motor 1/2 HP
Reciprocating Saw
Microwave Oven
Refrigerator/Freezer
Sump Pump 1/2 HP
Vacuum Cleaner
Well Pump 1/2 HP
RuNNiNG START-uP
WATTS WATTS
720 1000
1200 2400
700 1200
875 2300
750 1400
1000 1200
700 2200
1050 2150
1100 2200
1000 2100
Page 12