Installation; Operation - Chicago Electric 45416 Assembly And Operating Instructions Manual

When unpacking, check to make sure the Generator is complete. If any parts are missing or
broken, please call Harbor Freight Tools at the number on the cover of this manual as soon
as possible.
1. Verify that the driver motor is securely mounted to a stable surface (see Mounting Plate
instructions on pages 5 and 6), and belt pulleys properly attached. Refer to the photo
below.
2. Mount the double pulley (not supplied) onto the Generator (1 inch) shaft. Make sure
that the pulley set screws are properly tightened.
3. On the same surface, mount the Generator, offset to the shaft of the motor driver.
The belts should be placed on the pulleys to determine the proper distance between
drive shafts. Allow room for adjustments after mounting the Generator.
4. For safe operation, install a pulley guard (not included) around both pulleys.
Generator
Double Pulley
Motor Drive
1. Plug in the extension cords or appliances, making sure they are turned off.
Refer to the connector wiring illustration on the next page. Do not overload the
Generator. Calculate the total wattage of the appliances. Generator maximum power
output is 10,000 watts.
2. Start the motor driver.
3. Begin using the appliances when the motor driver is at full speed.
4. If electricity to one of the outlets stops, it could be that the circuit was overloaded.
Check you appliance wattage, then push in on the Reset button to resume power.
SKU 45416
Unpacking

Installation

Generator
Motor Drive Double Pulley

Operation

Page 7 REV 04/02