Cleaning, Maintenance, And Lubrication; Maintenance And Servicing; Replacing The Carbon Brushes - Drill Master 94245 Set Up And Operating Instructions Manual

MAINteNANCe ANd
SeRVICINg
Procedures not specifically
explained in this manual must
be performed only by a qualified
technician.
FROM ACCIdeNtAL
OpeRAtION:
turn the power Switch of the tool
off and unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
tO pReVeNt SeRIOUS INjURY
FROM tOOL FAILURe:
do not use damaged equipment.
If abnormal noise or vibration
occurs, have the problem
corrected before further use.
Cleaning, Maintenance, and
Lubrication
1. Before each use,
condition of the Circular Saw. Check for
loose screws, misalignment or binding of
moving parts, cracked or broken parts,
damaged electrical wiring, and any
other condition that may affect its safe
operation. If abnormal noise or vibration
occurs, have the problem corrected
before further use.
do not use damaged equipment.
2. Before remounting the Saw Blade,
remove all sawdust that has
accumulated around the safety guard.
SKU 94245
tO pReVeNt
SeRIOUS INjURY
inspect the general
For technical questions, please call 1-800-444-3353.
3. Regularly inspect and tighten all
mounting screws and knobs.
4. Keep Saw Blade clean and sharp. Sharp
blades minimize stalling and kickback.
5. Keep guards in good working order.
6. Keep motor air vent clean of dust and
debris. Vacuum periodically.
7. If the tool is not operating normally,
making unusual noises, or appears
defective, stop using it immediately and
get it repaired.
8. Clean tool with a damp cloth and light
detergent. Do not use solvents as they
can damage and crack the plastic parts.
9. WARNINg! If the supply cord of
this power tool is damaged, it must be
replaced only by a qualified service
technician.

Replacing the Carbon Brushes

1. Unscrew the Carbon Brush Covers (55).
2. Pull out the Carbon Brush (54) from each
side of the motor and examine them.
If they are worn more than half way
down, replace them. It could be that they
are simply dirty. They can be cleaned
using an ink eraser.
3. Replace the Carbon Brushes (54) and
Covers (55).
Page 14