Meyer Sound MM-10 Operating Instructions Manual page 47

6. Solder the five exposed conductors to the five pins on the EN3 cord connector using the following wiring scheme.
Pin #5, White,
audio (+)
Pin #4, Blue,
audio (–)
Pin Destinations for EN3 5-Pin Female Cable Mount Connector
7. Reassemble the EN3 5-pin female connector:
Align the coupling ring's side notches with the cord connector's side notches and slide the couple ring onto the cord
■
connector.
■ Carefully insert the end of the cable clamp housing into the cord connector until it locks into place. Snap the cable
clamps in the cable clamp housing into their compartments.
■ Slide the boot forward so it covers the cable clamp housing completely.
ASSEMBLING PHOENIX-TO-PHOENIX LOUDSPEAKER CABLES
When connecting MM-10XP loudspeakers equipped with Phoenix connectors to the MPS-488HPp power supply, you need
a Phoenix 5-pin female to Phoenix 5-pin female cable. The following procedure documents how to assemble this cable.
Assembled Phoenix-to-Phoenix Cable
To assemble a Phoenix-to-Phoenix cable:
1. If the cable has not yet been stripped, strip one end of the cable. Strip the outer shielding by 1" and then strip the black,
red, blue, and white wires by .275".
Dimple identifies Pin #1
Pin #1, Black,
48 V DC (–)
Pin #2, Red,
48 V DC (+)
FRONT Pin #3, Unshielded,
audio shield
1"
0.275"
MM-10 OPERATING INSTRUCTIONS
Pin #5, White,
audio (+)
Pin #4, Blue,
audio (–)
REAR
47