APPENDIX C: PHOENIX AND EN3 CABLE ASSEMBLY
2. Insert the five exposed conductors into the five cable holes in the Phoenix connector using the following wiring scheme.
Side (cable attached)
Phoenix 5-Pin Female Cable Mount Connector
3. Secure the conductors by tightening the five screws in the Phoenix conductor.
4. Disassemble the EN3 5-pin female connector and feed one end of the cable through the boot, cable clamp housing, and
coupling ring.
Boot
Disassembled EN3 5-Pin Female Cable Mount Connector
5. If the EN3 end of the cable has not been stripped, strip the outer shielding 1" and then strip the black, red, blue, and
white wires .275".
46
Pin #1
Pin #2
Pin #3
Pin #4
Pin #5
Tighten screws
Coupling ring
Cable clamp
housing
Black
48 V DC (–)
Red
48 V DC (+)
Unshielded
Audio shield
Blue
Audio (–)
White
Audio (+)
Cord connector
Connector side up