Inverter Keypad Operation - Hitachi L100 Series Quick Reference Manual

Inverter Keypad Operation

Run Key Enable LED
Run/Stop LED
RUN
PRG
FUNC.
Run Key
Function Key
• Run/Stop LED – ON when the inverter output is ON and the
motor is developing torque, and OFF when the inverter output is
OFF (Stop Mode).
• Program/Monitor LED – ON when the inverter is ready for
parameter editing (Program Mode). It is OFF when the parameter
display is monitoring data (Monitor Mode).
• Run Key Enable LED – ON when the inverter is ready to
respond to the Run key, OFF when the Run key is disabled.
• Run Key – Press this key to run the motor (the Run Enable LED
must be ON first). Parameter F_04, Keypad Run Key Routing,
determines whether the Run key generates a Run FWD or Run
REV command.
• Stop/Reset Key – Press this key to stop the motor when it is
running (uses the programmed deceleration rate). This key will
also reset an alarm which has tripped.
(continued, next page...)
Parameter Display
Program/Monitor LED
HITACHI
5 0.0
STOP
RUN
RESET
2
1
Up/Down Keys
POWER
Hz
A
MAX
MIN
STR
Store Key
5
Power LED
Display Units LEDs
Hertz
Amperes
Potentiometer
Enable LED
Potentiometer
Stop/Reset Key