The Power-On Self Test (Post) - EUROCOM M120 VOYAGE User Manual

BIOS Utilities
Post Screen
1. BIOS information
2. CPU type
3. Memory status
5
4. Enter Setup prompt
appears only during
POST
Note: The POST screen
as pictured is a guide-
line only. The POST
screen on your compu-
ter may appear slightly
different.
Figure 5 - 1
Post Screen
Example

5 - 2 The Power-On Self Test (POST)

The Power-On Self Test (POST)
Each time you turn on the computer, the system takes a few seconds to con-
duct a POST, including a quick test of the on-board RAM (memory).
As the POST proceeds, the computer will tell you if there is anything wrong.
If there is a problem that prevents the system from booting, it will display a
system summary and prompt you to run Setup.
If there are no problems, the Setup prompt (Press <F2> to enter SETUP) will
disappear and the system will load the operating system. Once that starts, you
can't get into Setup without rebooting.
Boot Logo Screen
If you have enabled
the Boot Logo Screen
then the POST screen
will not appear.
You
can still press F2 to en-
ter Setup (see "Intel
On-Screen Branding
Logo" on page 5 - 9).
Phoenix NoteBIOS 4.0 Release 6.0
Copyright 1985-2003 Phoenix Technologies Ltd.
All Rights Reserved
CPU = Intel(R) Celeron(R) M processor
3
239M System RAM Passed
512K Cache SRAM Passed
KBC Version 1.00.P1
System BIOS shadowed
Video BIOS shadowed
4
Press <F2> to enter SETUP
1
2
1200MHz