Setting The Cache Test And Use Control Options - Epson Progression 4 Setup Manual

You
may want to disable caching in a certain address area to
avoid any memory conflicts if you install an option card or
other device that uses the same address area.
To change the setting of one or more
Cache control Areas, select an address area and press a
or [-1 to choose Enabled or Disabled.
To disable caching in one or more
Non-cached Areas, you set the beginning address
range in a low address option; then you set the ending address
in the corresponding high address option.
First hi highlight the low address option and press m Then
press + or~toscrollthrou h the addresses in 4KB
increments; or press m or b
increments. (You see the corresponding high address option
setting hcrease at least 4KB higher than the low address.) Once
you set the low address, set the corresponding high address in
thesamemanner.
Note
You cannot use these SEIVP
may have installed on an

Setting the Cache Test and Use Control Options

Using SETUP, you can enable or disable your computer's
internal cache (built into the microprocessor). The default
setting for the Internal cache option is Enabled
You may need to disable the cache if it malfunctions or if you
use timing-loop-dependent software that requires a slower
system speed. Check your software documentation to see if this
is necessary.
system
User
options to
option card.
Running the SETUP Program
Defined
Defined
of the
cache any RAh4 you
2-25