Table of Contents
Advertisement
To run the INSTALL program:
1. Type INSTALL at the DOS prompt in the directory con-
taining the driver install files.
2. INSTALL asks you to select the software to install. Then
choose d:\EloDW from the displayed list.
3. INSTALL also asks you for the paths to use during in-
stallation, or you may use its defaults. INSTALL creates
directories as necessary, and warns you if they exist.
If you are updating your software, you may wish to specify the
paths containing the earlier versions, and overwrite the obsolete
files. All executable programs are upward compatible. For a list
of differences from each previous version of the drivers, be sure
to select "Differences from Previous Versions" during the instal-
lation process.
INSTALL updates your AUTOEXEC.BAT file with the drivers you
select. INSTALL makes a copy of your original AUTOEXEC.BAT
called AUTOEXEC.OLD. If you already have Elo driver commands
in your AUTOEXEC.BAT file, they will be commented out.
When INSTALL is finished, it leaves a file called GO.BAT in the
subdirectory you specified. GO loads the touchscreen driver,
runs the calibration program ELOCALIB, and gives you some
final instructions.
If you are using Windows 3.1, you will also calibrate the
touchscreen within Windows 3.1 with the Touchscreen Control
Panel.
Advertisement
Table of Contents
