Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Elo TouchSystems 5000
Summary of Contents for Elo TouchSystems 5000
- Page 1 Touchmonitor User Guide 1928L 19” LCD Desktop Touchmonitor 5000 Series Revision B...
-
Page 2: User Guide
User Guide 1928L 19” LCD Desktop Touchmonitor Revision B P/N E116103... - Page 3 Elo TouchSystems reserves the right to revise this publication and to make changes from time to time in the content hereof without obligation of Elo TouchSystems to notify any person of such revisions or changes. Trademark Acknowledgments Elo Touchsystems AccuTouch and IntelliTouch are trademarks of Tyco Electronics Corporation.
-
Page 4: Warnings And Cautions
Warning • Danger - Explosion hazard. Do not use in the presence of flammable anesthetics, and other flammable materials. • To prevent fire or shock hazards, do not immerse the unit in water or expose it to rain or moisture. •... -
Page 5: Caution-Life Support
CAUTION-Life Support Care must be taken when this touchmonitor is a critical component of a life support system or device. In case of failure of this touchmonitor, appropriate redundant systems should be incorpo rated into the system or device to prevent injury to the user or patient. The following should be an integral part of the safety design of a life support system or device using this touchmonitor for a critical function. -
Page 6: Classification
Classification With respect to electrical shock, fire in accordance with UL60601-1 and CAN/CSA C22.2 No. 60601-1 This monitor is a CLASS 1 (GROUNDED) DEVICE. These displays are classified NO APPLIED PARTS EQUIPMENT. Protection against harmful ingress of water: INGRESS PROTECTION(IPX1) This monitor shall be classified as ORDINARY EQUIPMENT, not intended or evaluated for use in the presence of flammable anesthetic mixture with air, oxygen, or nitrous oxide. -
Page 8: Table Of Contents
Warnings and Cautions ... iv Caution-Life Support ... v Classification ... vi Chapter 1 INTRODUCTION Product Description ... 1 LCD Display Performance Features ... 2 19 inch TFT LCD Display Panel ... 2 External Medical Grade Power Supply ... 2 Chapter 2 INSTALLATION AND SETUP Unpacking Your Touchmonitor ... -
Page 9: Introduction
C H A P T E R NTRODUCTION Product Description The 1928L is a medical display designed to present information to the operator and the customer. The 1928L is available in serial and USB(combo) touch interface as well as no touch. The 1928L functionally consists of a 19”... -
Page 10: Lcd Display Performance Features
LCD Display Performance Features 19” TFT LCD Display Panel Display format Display area Pixel pitch Contrast Ratio Brightness AccuTouch IntelliTouch Accutouch transmission Intellitouch transmission Response time Display color Typical vertical viewing angle Typical horizontal viewing angle External Medical Grade Power Supply The 1928L is powered by an external medical grade universal input AC power source. -
Page 11: Installation And Setup
C H A P T E R NSTALLATION ETUP This chapter discusses how to install your LCD touchmonitor and how to install Elo TouchSystems driver software. Unpacking Your Touchmonitor Check that the following items are present and in good condition:... -
Page 12: Product Overview
Product Overview Main Unit Back Unit Side View Elo Touchmonitor User Guide... -
Page 13: Base Bottom View
Base Bottom View Kensington Lock The Kensington lock is a security device that prevents theft. To find out more about this secu rity device, go to http://www.kensington.com. -
Page 14: Touch Interface Connection
Touch Interface Connection Note: Before connecting the cables to your touchmonitor and PC, be sure that the computer and touchmonitor are turned off. STEP 1-Connecting the Video Cable • Tilt the screen up and back to access the connection ports. •... -
Page 15: Step 2 Connecting The Serial/Usb Cable
STEP 2-Connecting the Serial and USB Touchscreen Cable CONNECTORS ON THE UNDERSIDE USB CONNECTOR FEMALE 9-PIN SERIAL TOUCHSCREEN CONNECTOR • Connect the female end of the serial (RS-232) cable to the serial port on your PC, or connect the USB touchscreen cable to the USB touchscreen connector on the back of your touchmonitor. -
Page 16: Step 3 Connecting The Speaker Cable
STEP 3-Connecting the Speaker Cable • Connect the light blue end of the speaker cable to the light blue speaker port to the monitor (audio in). • Connect the lime (light green) end of the speaker cable to the lime speaker port on the computer (audio out). -
Page 17: Step 4 Connecting The Power Cable
STEP 4-Connecting the Power Cable CONNECTIONS ON UNDERSIDE POWER Depending on where you live, you will use either the European or US/Canadian power cable. • Connect the female end of the power cable to the medical grade power adaptor. • Connect the brick power cable into the power port on the touchmonitor. -
Page 18: Optimizing The Lcd Display
OS/2 Additional drivers and driver information for other operating systems (including Macintosh and Linux) are available on the Elo TouchSystems web site at www.elotouch.com. Your Elo USB touchmonitor is plug-and-play compliant. Information on the video capabilities of your touchmonitor is sent to your video display adapter when Windows starts. If Windows detects your touchmonitor, follow the instructions on the screen to install a generic plug-and-play monitor. -
Page 19: Operation
C H A P T E R PERATION About Touchmonitor Adjustments Your touchmonitor will unlikely require adjustment. Variations in video output and application may require adjustments to your touchmonitor to optimize the quality of the display. For best performance, your touchmonitor should be operating in native resolution, that is 1280 x 1024 at 60-75 Hz. -
Page 20: Front Panel Controls
Front Panel Controls Control 1 Menu/Exit 4 Select 5 Power Switch 3-12 Elo Touchmonitor User Guide Function Display/Exits the OSD menus. 1. Enter contrast of the OSD. 2. Increase value of the adjustment item. 3. Shuffle item clockwise. 1. Enter audio volume adjustment. 2. -
Page 21: Controls And Adjustment
Controls and Adjustment OSD Menu Functions To Display and Select the OSD Functions: 1 Press the Menu key to activate the OSD menu. 2 Use on the monitor. The parameter will be highlighted when selected. 3 To quit the OSD screen at any time during the operation, press the Menu key. If no keys are pressed for a short time period, the OSD automatically disappears. -
Page 22: Osd Control Options
OSD Control Options Control Contrast Brightness V-Position H-Position Recall Defaults Color Balance Audio Volume Sharpness Phase Clock OSD H-Position OSD V-Position OSD Time Auto-Adjust OSD Language Information Description Indicates the current resolution, H-Frequency and V-Frequency. 3-14 Elo Touchmonitor User Guide Description Increases or decreases contrast. -
Page 23: Power Led Display & Power Saving
Power LED Display & Power Saving General Power Saving Mode When the power is on and video is present, this LED lights in green. The LED indicates the different power status with altered LED colors when monitor operates in different modes (see following table). - Page 24 3-16 Elo Touchmonitor User Guide...
-
Page 25: Troubleshooting
If you are experiencing trouble with your touchmonitor, refer to the following table. If the prob lem persists, please contact your local dealer or our service center. Elo Technical Support num bers are listed on page 31 of this manual. Solutions to Common Problems Problem The monitor does not respond... - Page 26 3-18 Elo Touchmonitor User Guide...
- Page 27 The native resolution of a monitor is the resolution level at which the LCD panel is designed to perform best. 1928L native resolution is 1280 x 1024. In almost all cases, screen images look best when viewed at their native resolution. You can lower the resolution setting of a monitor but not increase it.
- Page 28 As an example, a SVGA resolution LCD panel has 800 pixels horizontally by 600 pixels vertically. Input video is also represented by the same terms. XGA input video has a format of 1280 pixels horizontally by 1024 pixels vertically. When the input pixels contained in the video input format match the native resolution of the panel, there is a one to one correspondence of mapping of input video pixels to LCD pixels.
-
Page 29: Touchmonitor Safety
This manual contains information that is important for the proper setup and maintenance of your touchmonitor. Before setting up and powering on your new touchmonitor, read through this manual, especially Chapter 2 (Installation), and Chapter 3 (Operation). To reduce the risk of electric shock, follow all safety notices and never open the touchmonitor case. -
Page 30: Care And Handling Of Your Touchmonitor
Care and Handling of Your Touchmonitor The following tips will help keep your Elo touchmonitor functioning at the optimal level. • To avoid risk of electric shock, do not disassemble the external power adaptor or display unit cabinet. The unit is not user serviceable. Remember to unplug the display unit from the power outlet before cleaning. -
Page 31: Technical Specifications
Display Modes Your Elo touchmonitor is compatible with the following standard video modes: Item Resolution 640 x 350 720 x 400 640 x 480 640 x 480 640 x 480 640 x 480 800 x 600 800 x 600 800 x 600 800 x 600 832 x 624 1024 x 768... -
Page 32: Touchmonitor Specifications
Touchmonitor Specifications Parameter LCD Display Pixel Pitch Display Mode Native Contrast Ratio Brightness AccuTouch IntelliTouch Response Time Display Color Viewing Angle Input Signal Signal Connector Front Control Plug & Play Touch Panel Power External Power Supply* Monitor Environmental Temp. Operating Storage/Transportation -20 Humidity (non-condensing) Operating... -
Page 33: Power Supply Cord Selection
Power Supply Cord Selection North America Power Supply Cord ¡V Detachable, UL Listed, Type SJT 3 conductor, 18 AWG, configured load fittings terminating in molded on parallel blade. Grounding type hospital grade attachment plug, rated at a minimum of 3 amperes. Basic Cord Type SP-2 SP-3... -
Page 34: Cord Selection For Other Than North America
Cord selection for other than North America For 100 V ac or 220/230/240 V ac operation, the unit is provided with IEC 320 flexible power cords properly configured for the intended country other than North America. The NOMINAL cross-sectional area (mm2 Cu) must be 0,75. For assistance in selecting the proper power cord contact the Elo distributor in your area or contact Elo (see Appendix D, page 23) Country Argentina... - Page 35 HAR FLEXIBLE CORD Approval Organization Comite Electrotechnique Belge (CEBEC) Verband Deutscher Elektrotechniker (VDE) e.V. Prufstelle Union technique de l'Electricite (UTE) Instituto Italiano del Marchio di Qualita (IMQ) British Approvals Service for Electric Cables (BASEC) N> V. KEMA SEMKO AB Svenska Elektriska Materielkontrollanstalter Österreichischer Verband fur Elektrotechnik (ÖVE)
-
Page 36: Accutouch (Resistive) Touchscreen Specifications
AccuTouch (resistive) Touchscreen Specifications Mechanical Positional Accuracy Touchpoint Density Touch Activation Force Surface Durability Expected Life Performance Sealing Optical Light Transmission (per ASTM 90% D1003) Visual Resolution Gloss (per ASTM D2457 using a 60-degree gloss meter) Environmental Chemical Resistance Electrostatic Protection (per EN 61 000-4-2, 1995) C-28 Elo Touchmonitor User Guide... -
Page 37: Intellitouch (Resistive) Touchscreen Specifications
IntelliTouch Touchmonitor Specifications Mechanical Positional Accuracy Touchpoint Density Touch Activation Force Surface Durability Expected Life Performance Sealing Optical Light Transmission (per ASTM D1003) Visual Resolution Gloss (per ASTM D2457 using a 60 degree gloss meter) Standard deviation of error is less than 0.080 in. (2.03 mm). Equates to less than ±1%. - Page 38 C-30 Elo Touchmonitor User Guide...
-
Page 39: Contact Elo
P E N D I X Contact Elo Elo TouchSystems 301 Constifution Drive Menlo Park, CA 94025 1-800-ELO-TOUCH (1-800-356-8682) www.eloinfo.elotouch.com D-31... - Page 40 D-32 Elo Touchmonitor User Guide...
-
Page 41: Regulatory Information
EGULATORY I. Electrical Safety Information: A) Compliance is required with respect to the voltage, frequency, and current requirements indicated on the manufacturer’s label. Connection to a different power source than those specified herein will likely result in improper operation, damage to the equipment or pose a fire hazard if the limitations are not followed. - Page 42 D) General Information to all Users: This equipment generates, uses and can radiate radio fre quency energy. If not installed and used according to this manual the equipment may cause interference with radio and television communications. There is, however, no guarantee that interference will not occur in any particular installation due to site-specific factors.
-
Page 43: Warranty
ARRANTY Except as otherwise stated herein or in an order acknowledgment delivered to Buyer, Seller warrants to Buyer that the Product shall be free of defects in materials and workmanship. The warranty for the touchmonitors and components of the product is 3 years. Seller makes no warranty regarding the model life of components. - Page 44 THESE REMEDIES SHALL BE THE BUYER’S EXCLUSIVE REMEDIES FOR BREACH OF WARRANTY. EXCEPT FOR THE EXPRESS WARRANTY SET FORTH ABOVE, SELLER GRANTS NO OTHER WARRANTIES, EXPRESS OR IMPLIED BY STATUTE OR OTHERWISE, REGARDING THE PRODUCTS, THEIR FITNESS FOR ANY PURPOSE, THEIR QUALITY, THEIR MERCHANTABILITY, THEIR NONINFRINGEMENT, OR OTHERWISE.
-
Page 45: Index
Numerics ET1928L-XXWA-1-G About touchmonitor Adjustments, 11 AccuTouch(resistive)Touchscreen Specifications, 28 Audio Volume, 14 Auto-Adjust, 14 Back Unit, 4 Base Bottom View, 5 Brightness, 14 Care and Handling of your Touchmonitor, 22 Caution-Life Support, v Classification, vi Clock, 14 Color Balance, 14 Connecting the Video Cable, 6 Connecting the Serial and USB Touchscreen Cable, 7 Connecting the Speaker Cable, 8... - Page 46 Rear View, 10 Recall Defaults, 14 Regulatory Information, 33 Sealing, 28, 29 Sharpness, 14 Side View, 4 Solutions to Common Problems, 17 Surface Durability, 28, 29 SVGA, 19 Technical Specifications, 23 Touch Activation Force, 28, 29 Touch Interface Connection, 6 Touch doesn’t work, 17 Touchmonitor Safety, 21 Touchmonitor Specifications, 24...
-
Page 47: Product Information
To find out more about Elo’s extensive range of touch solutions, visit our Web site at www.elotouch.com or simply call the office nearest you: USA & Headquarters Germany Elo TouchSystems Elo TouchSystems GmbH & Co. KG 301 Constitution Drive Haidgraben 6 Menlo Park, CA 94025 D-85521 Ottobrunn...