Stylus Scan Errors - Epson STYLUS Scan 2000 Service Manual

EPSON Stylus Scan 2000

1.5 Stylus Scan Errors

PRINTER
Table 1-23. Printer Related Errors
Error Cause
When one or more ink cartridges are
almost empty, the printer enters the low-
ink state and continues printing.
Ink out
When the cartridge is completely empty,
the printer indicates an ink-out error and
stops printing.
If the printer fails to properly load paper,
Paper out
it indicates a paper-out error.
If the printer fails to properly eject paper,
Paper jam
it indicates a paper jam.
If the printer detects that one of the ink
No ink
cartridges is not installed, it indicates a
cartridge
no-ink-cartridge error.
When the total amount of waste ink
Maintenance
reaches the limit, the printer indicates a
request
maintenance request and stops printing.
A carriage control or CG access error has
Fatal error
occurred.
NOTE: Do not re-install used ink cartridges. Doing so confuses the ink-
level detection function and may cause a serious problem in the
printhead.
Product Description
SCANNER
Error
Solution
Fatal error
Install a new ink
cartridge.
Load paper and press
Command
the Load/Eject button.
error
Press the Load/Eject
button. If this does not
clear the error, remove
the paper by hand.
Install a new ink
cartridge.
Replace the waste ink
pads.
Turn off the Stylus
Scan and turn it back
on. If the error does not
clear, service.
Stylus Scan Errors
Table 1-24. Scanner Related Errors
Cause
• The lamp is broken.
• System breakdown.
• Scanner fails to eject the document.
• (Disposition)
Unidentified command detected.
(Disposition)
The scanner sent a NACK signal and is
waiting for the next command. If an
incorrect command or parameter is
received, it is disregarded and the
previous value is maintained.
Revision A
Solution
Turn off the Stylus
Scan and turn it back
on. If the error does not
clear, service.
Turn off the lamp and
stop operation. Set bit 7
of the status byte.??
Send a correct
command to clear the
error.
28