Epson Stylus Pro Service Manual page 89

Stylus Pro XL
9. Rerun the BASIC program and choose "Head Angle Confirmation Pattern" again by typing 2
and ENTER. Then verify that the confirmation sample is correct.
Carriage Unit
1: Push
Head Base
Figure 4-17. YMC Angular Spacer Replacement
10. If the sample is incorrect, repeat steps 5-9 until the upper lines in the sample are aligned with
one another and the lower lines in the sample are exactly equidistant to one another (as shown
at B in Figure 4-15).
11. When you complete this adjustment, turn off the printer.
Rev. A
Color Head
Platen Gap Adjust Lever
Angular Spacer
(one side only)
Adjustments
2: Replace
4-15