Epson Stylus Pro Service Manual page 88

Adjustments
7.
Remove the rubber cap covering the head screw at one side of color ink cartridge. Then loosen
(but do not remove) 3 screws. (Refer to the figure below.)
8. Replace the angular spacer on the left side with a new one, referring the figure below. (Replace
the angular spacer using tweezers to push the head base toward the rear.)
4-14
Ru bber Cap
Screw 1
Screw 2
Figure 4-16. Removing the Rubber Cap
Screw 3
Stylus Pro XL
Rev. A