Epson Stylus Pro XL Service Manual page 45

Adjustment
5. If the sample print is not vertically aligned for both the odd-numbered and even-numbered lines, enter a
compensation value in the range from –30 to +30.
Positive compensation value: Shifts the 2nd line to the left
Negative compensation value: Shifts the 2nd line to the right
When the sample print becomes vertically aligned for both lines, press Y and ENTER; then the printer
prints out the current Bi- D setting pattern, and this returns you to the 360 DPI Bi-d adjustment mode.
6. Adjust the 360 DPI Bi-d setting mode in the same way as 720 dpi Bi-D adjustment.
7. If you have finished the 360 dpi Bi-d adjustment, choose "10, END" by typing 10 and pressing
ENTER. (The destination setting menu appears on the display again.)
8. Choose "7, END" by typing 7 and pressing ENTER to quit the adjustment program.
Settings have not been written to the EEPROM yet. Turn off the printer immediately after the
adjustments.
9. Turn off the printer.
4-18
Stylus Pro XL+ Service Manual
Rev.A