Epson Stylus Pro XL Service Manual page 33

Adjustment
1. Connect the PC to the target printer using a parallel interface cable and turn the printer on.
2. Load BASIC on the PC, and run the program. You see the following destination select menu.
***** Customer *****
1. EAI, EAI (Latin America), EAL, ESP
2. EDG, EUL, EFS, EIS, EIB, EUL (Northern Europe), EUL (Middle East), EHK
3.
4. JAPAN
5.
6.
7. END
Select Menu ?
3. Input the number for the destination. Then the main menu appears, as shown below.
If you enter an incorrect number as the destination selection, printer functions are not
guaranteed.
STYLUS Pro XL+ Program : Rev. X
customer :
1. Head VH input
2. Ink consumption counter reset
3. Head angular & linear adjustment
4. Head position check
5. BK. YMC head gap adjustment (head gap center )
6. Bi-D adjustment
7. Head VH indication
10. Change customer & data / END
0. Cleaning
Select Menu ?
4. Choose "3, Head angular & linear adjustment" by typing 3 and pressing ENTER. (The printer prints the
check pattern, along with the sample name. )
When you replace both the black and color heads, always adjust the color head angle first.
The black head angle is based on the color head angle.
After you replace the black head and print the black head angle pattern, you only have
to insert an angular spacer if the pattern is incorrect.
4-6
(Bi-d center )
Stylus Pro XL+ Service Manual
Rev.A