Removing The Pe Paper Detector Assembly - Epson Stylus Color 400 Service Manual

3.2.4.9 Removing the PE Paper Detector Assembly

1. Remove the housing.(Refer to 3.2.1)
2. Release two fixed hooks securing the PE detector assembly from the back of frame and remove the
PE detector assembly, sliding it upward. Remove PE board assembly and PE lever if necessary.
During assembly, make sure that the tip(sensor part) of the detector lever is in the hole of paper guide
assembly.
Figure 3-23. Removing the PE Paper Detector Assembly
Rev. A
Chapter3 Disassembly and Assembly
WORK POINT
3-25