Epson Stylus Color 400 Service Manual page 102

EPSON Stylus Color 400 Service Manual
9. Loosen a screw securing the print head on the carriage.
(It is not necessary to remove it completely: Refer to the figure below.)


Make sure to loosen the screw. If the screw is not loose, the print head angle can not be
changed even if the position of the adjust lever is moved.
10. Pay attention to the combination pattern of black/magenta and change the position of the adjust lever
so that a magenta line comes to between above and below black lines, adjusting the print
head angle by the adjust lever. The figure 4-6 below shows changes of actual printing pattern of
black/magenta combination with the operation of the adjust lever.
Figure 4-6. Adjustment of Combination Pattern of Black and Magenta
11. After changing the position of the adjust lever, press "Y" key and return the carriage to the
home position.
12. Check again the combination pattern of black/magenta after changing the position of the adjust lever.
13. Repeat the procedures from 7 to12 until the combination pattern of black/magenta comes to
proper position.
14. After completing adjustment, select "K" (Angular Adjust Setting) on the main screen [Screen-6] and
tighten the loosen screw steadily.
4-8
Figure 4-5. Position of the Print Head
CAUTION
Rev. A