Initialize Operation - Epson Stylus COLOR 1520 Service Manual

EPSON Stylus &2/25 1520

4.1.2 Initialize Operation

This operation is performed to write the factory values in the EEPROM on the MAIN board. With this
operation, the factory values are written in at a time.
1. Connect the printer and the host computer with a parallel interface cable.
2. Start the adjustment program in the host computer.
3. Select
4. Move the cursor using
Enter key, and the main menu appears on the monitor.
5. Move the cursor using
the main menu appears on the monitor.
6. Move the cursor using
initialization. Then press the Enter key to return to the main menu.
7. Select other adjustment using
8. Move the cursor using
Note
1. Unless
2. Input of an incorrect customer code does not assure the proper operation of the program.
; Adjusted values are not stored in the EEPROM until the printer is turned off. Therefore be sure to
turn off the printer once after the adjustment program is executed.
; The set value is transferred to the printer when this operation is executed. Therefore do not turn
off the printer before executing "
4-4
in the 1 st menu and press the Enter key.
or key to select an appropriate customer code and area. Then press the
or key to select
or key to select "
or key, or select
or key to select
is executed, the program does not proceed to the main menu.
WORK POINT
.
in the 1st menu. Then press the Enter key, and
. Then press the Enter key to execute the
to exit the main menu.
and press the Enter key to exit the program.
Rev. A