Disassembly And Assembly; Adjustment; Overview; Precautions For Disassembling The Printer - Epson Stylus COLOR 1520 Service Manual

Hide thumbs Also See for Stylus COLOR 1520:
Table of Contents

Advertisement

3.1 Overview

This section describes procedures for disassembling the main components of EPSON Stylus COLOR
1520. Unless otherwise specified, disassembly units or components can be reassembled by reversing the
disassembling procedure. Therefore, no assembly procedures are included in this section. Precautions for
any disassembly or assembly procedure are described under the heading "WORK POINT". Any

adjustment

required after disassembling the units are described under the heading "REQUIRED
ADJUSTMENT".

3.1.1 Precautions for Disassembling the Printer

See the precaution below when disassembling and assembling EPSON Stylus COLOR 1520.
; Disconnect the power cable before disassembling and assembling the printer.
; Wear protective goggles to protect your eyes from ink. If ink gets in your eyes, flush the eye with
fresh water and see a doctor immediately.
; If ink comes into contact with your skin, wash it off with soap and water. If irritation occurs, contact
a physician.
; Be carefully not to get ink in your eyes. In case ink gets in your eyes, flush it with fresh water and
see a doctor immediately.
; A lithium battery is installed on the main board of this printer. Be sure to observe the following
instructions when servicing the battery:
ƒ Keep the battery away from any metal or other batteries so that electrodes of the opposite
polarity do not come in contact with each other.
ƒ Do not heat the battery or put it neat fire.
ƒ Do not solder on any part of the battery. (Doing so may result in leakage of electrolyte from the
battery , burning or explosion. the leakage may affect other device close to the battery.)
ƒ Do not charge the battery. (An explosive may be generated inside the battery, and cause burning
ƒ or explosion.)
ƒ Do not dismantle the battery. (The gas inside the battery may hurt your throat. Leakage , burning
or explosion may also be resulted.)
ƒ Do not install the battery in the wrong direction. (This may cause burning or explosion.)
Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent
type recommended by the manufacture. Dispose the used battery according to government's law and
regulations.
Risqué d'explosion si la pile est remplacèe incorrectment. Ne remplacer pue par une pile du même
type ou d'un type équivalent recommandé par le fabricant. Elimenir les piles déchargées selon les lois
et les règles de sécurité en vigueur.
Rev. A
WARNING
CAUTION
ATTENTION

Disassembly and Assembly

3-1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents