Generating A Program - Duerkopp Adler 550-12-23 Operating Instructions Manual

3.6 Deleting a Program

3.7 Generating a Program

16
- Hold the "Y" key down and hold down the "P" and "E" keys approx.
2 seconds until the blinking stops.
The program is deleted.
–
Press the "P" key.
–
Enter a three-digit model number which has not been used yet.
The left display blinks showing "---".
–
Hold the "Y" key down and tap the "P" key.
The dots in the middle display blink.
–
Enter the new crimping value.
–
Press the hand switch.
The entry value is stored in memory.
The next value can be entered.
Setting and deleting the end of a part
–
Mark the end of a part with the "E" key.
A small "e" appears to the right in front of the part number in the
display.
–
An end mark can be deleted again by pressing the "E" key again.
Exiting the programming mode
–
Hold the "Y" key down and tap the "P" key.
A capital "E" appears in front of the part number in the right display
as a program end marker.
The blinking dots disappear.
2 seconds after the pressing of the keys the first step of the model
appears in the display.