2.15.2
Basic setting with the control panel V810 or V820
1
Caution: Risk of injury !
The adjustment of the potentiometer is done with the main switch
switched on.
Work with utmost caution.
Loosen the stop screw 1 for the potentiometer 2.
–
–
Keep the key "P" pressed and switch on the main switch.
–
Enter the technician level.
–
Select the parameter "F-188".
–
Actuate the key "E".
The current Speedomat grade (e.g. 11) and the corresponding
driving speed limitation (e.g. 2000) are displayed.
Turn the potentiometer shaft until the Speedomat grade "07" and
–
the corresponding maximum driving speed of e.g. 2500 rpm
(depending on the subclass) is indicated on the display.
Tighten the stop screw 1.
–
–
Check the setting.
2
GB
57